Safire Associates, Unit 008, Solent Business Centre, 343 Millbrook road, Southampton, SO15 0HW
Copyright 2024 © All rights Reserved. Design by Safire
316 marine grade stainless steel and black acetal plastic subsea sampling clamps ROV
Parts machined from 316 marine grade stainless steel plate and black acetal plastic plate.
Plastic and Stainless machined parts made to fit together
These parts were part of marine life collection device that took marine samples from the seabed via a remote ROV. Manufactured from 316 marine grade stainless steel and block Acetal plastic. they were machined to close tolerances and inserted together,
Two of the machined parts are shown above, the machined Acetal is ready to be inserted into the stainless steel machined part.
One of the stainless steel parts shown above and below was machined from 20mm thick 316 marine grade plate.
we water jet cut the main shape with a plus tolerance then machine all over to the finished sizes of the part.
The Acetal parts were machined form 20mm thick Acetal plate and were of a close tolerance due to the depths they were going too when installed on the subsea ROV.
Some of the finished assembled parts machine in black acetal and 316 marine grade stainless steel plate are shown above and below ready for installation on the subsea ROV.
E7211