This roll bar was made mainly
for show, We accurately measured the hole locations on this short wheel base
Land Rover, then made the roll bar on a jig. You can see the attention to
detail and the accuracy of fitting from the close up photos.
When we make items like this we fill the tubes with a product then when bending
the tube it minimizes deformation of the tube. We can also make any tooling
necessary, This does however effect the price, if you can get this done in
a workshop with the right machine and tools it will most probably save you
money, but we will always do a good job that will look the best it can and
it will fit well!.
