Security doors and grills are often required we can make them fit most places, From simple lower budget gates to complete frames with heavier bars and locks. Most of the security gates and grills we get commissioned to make are for security and are industrial however we do get to make discreet security projects, Above right is a house Front door entrance that has a new frame fitted entirely made from steel, It had some features put on it to resemble a wooden frame so as not to raise suspicion that my client was trying to hide something, The whole frame and details were made from steel and then painted with a zinc based primer.
Below are 4 examples of lock systems we have designed and used to suit each application, below right shows a lock that has been built into the gate frame with clearance for the lock machined out of the frame for the workings, the lock was covered with steel plates on each side this helped to protect the lock from an attempt to brake it. You are not limited with off the shelf products, we can design a system to suit you.!

Below shows a double security door system built for a care sales garage, they wanted to be secure when locked but to use the area inside for valeting cars during the day, the biggest problem was the doorway was quite tight to get a car in and we had to design a way of opening the door but to have the door swing out to maximize the opening. I designed a frame with hinges sunk into the corner of the frame so as the door was shut it was on the inside of the frame as required, but when open the door was not obscuring any space of the opening. Also for the time when a really wide vehicle had to fit in the stop bars on the sides of the frame were easily removable.

Industrial Security is no problem but when it comes to homes or higher quality installations discreet security requires some thought. We have helped keep nice views by manufacturing discreet security bars, pictured around here are some interior bars, some were fitted to listed buildings where they were not allowed to be on the out side and equally they had to tie in with the decor of the building.
You can see how they tie in well with the windows, with careful measurements and some thought about the design of fittings, window grills can look part of the window itself.
We have made grills to closely match colors of the surroundings and in stainless steel. We have made them with a bit of design to look very contemporary or to match older traditional designs. We also make single security bars shown below and top left, these can be fitted over small openings or doors, or they can be used on windows with difficult fixing methods. Show below is a version bent at the bottom to miss a window sill.



















 

Security